Tools Power point presentation

The normally used tools are

  1. Hammer
  2. Hacksaw
  3. Chisel
  4. File
  5. Hand Saw
  6. Drilling Machine
  7. Screw Driver
  8. Neon Tester.

Hammer:- It is used as a striking tool. A claw hammer can be used for striking as well as pulling out nail.



Hack saw is used for cutting metal pieces. It has a removable blade which can be replaced on wear and tear.



It is used for cutting wooden pieces.It is a carpenter tool.



A file is a tool used to remove fine amounts of material from a workpiece. It is common in woodworking, metalworking, and other similar trade and hobby tasks. Most are hand tools, made of a case hardened steel bar of rectangular, square, triangular, or round cross-section, with one or more surfaces cut with sharp, generally parallel teeth. A narrow, pointed tang is common at one end, to which a handle may be fitted


File Types and Uses
Name Description
Square file Gradually tapered and cut on all four sides. Used for a wide variety of tasks
Half round file Has one flat and one convex surface, and either tapering slightly or maintaining an even thickness, width, or both over their length
Hand file Parallel in width and tapered in thickness, used for general work
Round/Rat tail Round in cross-section and gradually tapered over their length. They are used for enlarging round holes or cutting scalloped edges
Flat file Similar to a mill file, but may be double-cut
Combination file Tangless, flat sided or half-round, with two to four cutting surfaces, typically including a combination of single cut, double cut, or rasp
Mill file The most common shape, single-cut, rectangular in cross section, with an even thickness throughout their length; they may be either parallel sided or taper slightly in width from heel to end[8]
Three square/Triangular file Triangular in cross-section, which may taper gradually, often to a point on smaller files. The sides may be equal in cross-section, or have two long and one short surface

Hand Saw



In woodworking and carpentry, hand saws, also known as “panel saws”, “fish saws”, are used to cut pieces of wood into different shapes. This is usually done in order to join the pieces together and carve a wooden object. They usually operate by having a series of sharp points of some substance that is harder than the wood being cut. The hand saw is a bit like a tenon saw, but with one flat, sharp edge.

Electrical tools:-

Screw Driver

screw driver.jpg

It is used for loosening and tightening screws


adjistable spanner.jpg

Adjustable spanner


Ring Spanner

hand drilling machine.jpg

Hand drilling machine

electric drillig machine.jpg


Electric Drilling Machine



Jack plane

neon tester.jpg

Neon Tester

soldering iron.jpg

Soldering iron

desoldering pump.png

De-Soldering Pump

wire stripper.png

Wire Stripper